基于GNSS测量的天宫二号质心确定

由于轨道机动燃料消耗，科学载荷加载、分离，以及伴飞小卫星在轨释放等原因引起天宫二号空间站质心(COM)发生位移，从而影响天宫二号的动力学质心定轨精度。针对这一问题，提出了基于全球导航卫星系统(GNSS)测量数据的简化动力学质心估计方法。燃料消耗是引起天宫二号质心发生位移的主要原因，质心在本体坐标系X轴方向位移最为显著。利用GNSS测量数据对天宫二号进行质心估计和精密定轨，在三轴对地稳定姿态下，本体坐标系X轴方向与轨道切向重合，定轨结果对本体坐标系X轴方向的质心位移并不敏感。但在连续偏航模式下，本体坐标系X轴在轨道法向上有较大分量，X轴方向的质心位移对基于GNSS测量计算的精密定轨结果有较大影响。定性和定量分析结果表明:偏航姿态模式下天宫二号本体坐标系X轴方向质心位移估计具有可行性。天宫二号实测数据计算结果表明:与未做质心估计的定轨结果进行对比，质心估计后表征轨道动力学建模误差的经验加速度补偿水平在轨道径向、切向和法向上分别降低62%、50%和65%；载波相位后验残差标准差降低0.04 cm；精密轨道与全球激光测距数据比较精度提高0.86 cm。所提方法可以应用于大型低轨航天器在轨质心估计。      

翼尖铰接复合飞行器动力学特性研究

航空飞行器通过翼尖铰接机构复合飞行时的气动耦合效应，会造成飞机产生不同于其单独飞行时的动力学特性，出现复合飞行安全问题。为研究翼尖铰接复合飞行器的动力学特性，使用Newton-Euler方法和Robberson-Wittenburg方法建立了双机组成的翼尖铰接复合飞行器多刚体系统整体和内部的7自由度非线性动力学和运动学方程组。在气动准定常假设下建立双机复合系统非耦合气动力表达式，基于CFD方法开展复合飞行器系统的三维实体建模和非结构网格划分工作，获取复合飞行器系统的气动力数据。搭建动力学仿真平台，开展准配平方案和全配平方案下的动力学仿真。仿真结果表明:准配平方案下飞行器无法持续稳定飞行，而全配平方案下复合飞行器系统各运动参数在仿真时间内始终趋于稳定。在全配平方案下，使用小扰动假设的非解耦线性化方法重新整理7自由度动力学方程组，研究复合飞行器系统运动模态的特征值中出现的2个发散新模态，根据对应的特征向量发现2个发散模态分别由相对滚转角度和角速度主导，同时也比较分析了其他运动模态相比单机飞行时的特性变化规律。      

高超声速伸缩式变形飞行器再入制导方法

针对高超声速变形飞行器再入制导问题，提出了一种采用伸缩式机翼的高超声速变形飞行器外形方案，建立了含有展长变形量的气动模型和动力学模型。将该变形飞行器的展长变形量扩展为控制变量，分析了倾侧角、展长变形量和终端航程、高度之间的关系。在此基础上，利用倾侧角和展长变形量在线预测剩余航程和终端高度，通过数值方法校正2个控制量以满足航程约束和高度约束，通过航向角走廊确定倾侧角符号。仿真结果表明:该变形飞行器再入制导方法制导精度高，相比于传统固定外形飞行器终端约束能力更强、轨迹更加平滑，且在扰动条件下具有一定鲁棒性。      

空间载荷机柜热控设计的仿真研究

空间站主动热控系统的作用是提供和保持航天员、仪器设备和结构部件所要求的温度、湿度和风速等热环境。本文以空间载荷机柜为热控系统的基本单元，建立了以单相流体循环回路为基础、采用液冷结合风冷的冷却方式的载荷机柜数学模型；介绍了模糊增量控制算法的工作原理；提出了采用模糊增量控制算法，以液冷支路进出口温差和风冷支路冷却量占总冷却量的比值为控制目标的反馈控制策略。同时文章采用数值模拟方法研究了控制系统的动态响应效果。仿真结果显示，模糊增量控制算法具有响应迅速、超调量小、无静态误差的特点，控制策略满足有效性、稳定性和高精确度的要求。     

Fault mode probability factor based fault-tolerant control for dissimilar redundant actuation system

This paper presents a Fault Mode Probability Factor (FMPF) based Fault-Tolerant Control (FTC) strategy for multiple faults of Dissimilar Redundant Actuation System (DRAS) composed of Hydraulic Actuator (HA) and Electro-Hydrostatic Actuator (EHA). The long-term service and severe working conditions can result in multiple gradual faults which can ultimately degrade the system performance, resulting in the system model drift into the fault state characterized with parameter uncertainty. The paper proposes to address this problem by using the historical statistics of the multiple gradual faults and the proposed FMPF to amend the system model with parameter uncertainty. To balance the system model precision and computation time, a Moving Window (MW) method is used to determine the applied historical statistics. The FMPF based FTC strategy is developed for the amended system model where the system estimation and Linear Quadratic Regulator (LQR) are updated at the end of system sampling period. The simulations of DRAS system subjected to multiple faults have been performed and the results indicate the effectiveness of the proposed approach.     

Facile Fabrication of Hierarchical Porous N/O Functionalized Carbon Derived from Blighted Grains Towards Electrochemical Capacitors

The hierarchical porous N/O co-functionalized carbon(HPNOC)was scalably prepared by using the lowcost and renewable blighted grains as the raw material coupled with mild KHCO_3 activation for electrochemical capacitors(ECs).The elemental N was in situ doped in the obtained HPNOC without any N-containing additives.Remarkably,the obtained HPNOC was endowed with a large specific surface area(about 2 624m~2·g~(-1)),high pore volume(about 1.35cm~3·g~(-1)),as well as high-content N/O functionalization(about 1.9%(in atom)N and about 10.2%(in atom)O.Furthermore,the as-resulted HPNOC electrode with a high mass loading of 5mg·cm~(-2 )exhibited competitive gravimetric capacitances of about 373.6F·g~(-1 )at 0.5A·g~(-1),and even about 260.4F·g~(-1 )at a high rate of 10A·g~(-1);superior capacitance retention of about 98.8%at 1A·g~(-1 )over 10 000consecutive cycles;and high specific energy of about 9.6W·h·kg~(-1 )at a power of 500W·kg~(-1),when evaluated as a promising electrode in 6mol KOH for advanced electrochemical supercapacitors.More encouragingly,the green synthetic strategy we developed holds a huge promise in generalizing for other biomass-derived carbon materials for versatile energy-related applications.     

叶片式预旋喷嘴出口流场实验研究

叶片式预旋喷嘴具有尺寸小,落后角大的特点。为了详细研究小尺寸预旋喷嘴的预旋性能,采用五孔探针对叶片式预旋喷嘴的出口流场进行了实验研究。测量了Ma=0.2,0.3时喷嘴出口的压力分布、速度分布和出口气流角度分布,实验获得了喷嘴的落后角和预旋效率,并进行了与实验工况相同的数值计算。通过实验获得的总压云图以及速度云图,可以发现叶片式预旋喷嘴的端壁二次流损失、尾迹损失严重,有明显的边界层分离现象。Ma=0.2时,喷嘴Re数为5.76×104,落后角2.84°,实验测得的预旋效率为0.73;Ma=0.3时,喷嘴Re数为1.06×105,预旋效率提高至0.77。实验模型端壁的影响使预旋效率实验结果偏低6.5%左右。数值结果与实验测得各参数符合较好:数值结果与测得的喷嘴出口截面平均总压、静压偏差在1%以内;出气速度、周向速度以及出气角度与实验结果偏差在4%以内。数值计算表明,叶片式预旋喷嘴的预旋效率基本不受压比影响,随Re数增大先增大后基本不变,最后基本稳定在0.85。     

Impact of rain on wave retrieval from Sentinel-1 synthetic aperture radar images in tropical cyclones

The main objective of our work was to investigate the impact of rain on wave observations from C-band (~5.3 GHz) synthetic aperture radar (SAR) in tropical cyclones. In this study, 10 Sentinel-1 SAR images were available from the Satellite Hurricane Observation Campaign, which were taken under cyclonic conditions during the 2016 hurricane season. The third-generation wave model, known as Simulating WAves Nearshore (SWAN) (version 41.31), was used to simulate the wave fields corresponding to these Sentinel-1 SAR images. In addition, rainfall data from the Tropical Rainfall Measuring Mission satellite passing over the spatial coverage of the Sentinel-1 SAR images were collected. The simulated results were validated against significant wave heights (SWHs) from the Jason-2 altimeter and European Centre for Medium-Range Weather Forecasts data, revealing a root mean square error (RMSE) of ~0.5 m with a 0.25 scatter index. Winds retrieved from the VH-polarized Sentinel-1 SAR images using the Sentinel-1 Extra Wide-swath Mode Wind Speed Retrieval Model after Noise Removal were taken as prior information for wave retrieval. It was discovered that rain did indeed affect the SAR wave retrieval, as evidenced by the 3.21-m RMSE of SWHs between the SAR images and the SWAN model, which was obtained for the ~1000 match-ups with raindrops. The raindrops dampened the wave retrieval when the rain rate was < ~5 mm/hr; however, they enhanced wave retrieval for higher rain rates. It was also found that the portion of the rain-induced ring wave with a wave number > 0.05 rad/m (~125 m wavelength) was clearly observed in the SAR-derived wave spectra.